Audio-Technica AT-LP60XBT-WH Fully Automatic Bluetooth Belt-Drive Stereo Turntable

Entwodiksyon

The Audio-Technica AT-LP60XBT-WH is a fully automatic belt-drive stereo turntable designed for both wired and wireless audio playback. It features Bluetooth wireless technology for connecting to compatible speakers, headphones, or other devices, including support for the aptX codec for enhanced sound quality. The turntable also offers traditional wired connectivity via its dual RCA output cable. Its automatic operation simplifies playback with front-panel controls for start, stop, and tonearm lift. The unit incorporates a dual magnet cartridge with a replaceable stylus and plays records at 33-1/3 and 45 RPM speeds.

This image displays the Audio-Technica AT-LP60XBT-WH turntable from an elevated angle. The unit is white and black, with a clear, hinged dust cover lifted open. The black platter, featuring the Audio-Technica logo, is visible, along with the tonearm and stylus. Control buttons for speed, start, and stop are located on the front panel.

Kontni pake

Verifye ke tout atik sa yo enkli nan pakè ou a:

• AT-LP60XBT-WH Turntable Unit
• Detachable RCA output cable (3.5 mm male to dual RCA male)
• 45 rpm adaptè
• Kouvèti pousyè detachable gon

Enstalasyon

1. Plasman: Mete platin an sou yon sifas ki estab e plat, lwen limyè solèy dirèk, sous chalè, ak vibrasyon twòp.
2. Install Platter and Belt:
   • Carefully place the aluminum platter onto the turntable spindle.
   • Locate the drive belt, which is usually pre-installed on the underside of the platter or included separately.
   • Align the belt with the motor pulley, which is typically a small brass or plastic cylinder located near the spindle. Use the red tab to pull the belt over the motor pulley. Ensure the belt is not twisted.
   • Mete tapi a santi sou tèt plato a.
3. Enstale kouvèti pousyè a: Insert the hinges of the dust cover into the hinge holders at the rear of the turntable unit.
4. Konekte ak pouvwa: Connect the AC adapter to the turntable's power input and then plug it into a wall outlet.
5. Audio Koneksyon:
   • Koneksyon filaire: Connect the included dual RCA output cable from the turntable's output jacks to the audio input of your amplifier, powered speakers, or stereo system. Ensure the PHONO/LINE switch on the rear of the turntable is set correctly (PHONO for phono input, LINE for line input).
   • Koneksyon san fil (Bluetooth): Proceed to the Bluetooth Connectivity section for pairing instructions.

Enstriksyon Operasyon

1. Pouvwa sou: Press the power button on the front panel to turn on the turntable. The Bluetooth indicator will illuminate.
2. Chwazi vitès: Press the 'SPEED' button to select the appropriate playback speed for your record (33-1/3 RPM or 45 RPM).
3. Dosye Kote: Mete yon disk sou plato a. Si w ap jwe yon single 45 RPM, sèvi ak adaptè 45 RPM ki vini ak li a.
4. Kòmanse Lekti: Press the 'START' button. The tonearm will automatically move to the beginning of the record and begin playback.
5. One Stop lèktur: Press the 'STOP' button. The tonearm will automatically lift, return to its rest, and the platter will stop spinning.
6. Manual Tonearm Lift: Use the 'TONEARM LIFT' button to manually raise or lower the tonearm during playback if needed.

Koneksyon Bluetooth

The AT-LP60XBT-WH turntable can connect wirelessly to Bluetooth-enabled speakers, headphones, or other audio devices.

1. Aktive Bluetooth sou aparèy ou an: Ensure your Bluetooth speaker or headphones are in pairing mode. Refer to your device's manual for specific instructions.
2. Initiate Turntable Pairing: With the turntable powered on, press and hold the Bluetooth button (usually indicated by a Bluetooth symbol) on the turntable's front panel for a few seconds until the Bluetooth indicator light begins to flash rapidly. This indicates the turntable is in pairing mode.
3. Konekte: Once the turntable and your Bluetooth device are successfully paired, the Bluetooth indicator light on the turntable will change from rapidly flashing to a steady blue light.
4. Kodèk aptX: This turntable supports the aptX codec, which provides higher quality audio streaming over Bluetooth with compatible devices.

Antretyen

• Kouvèti pousyè: Keep the dust cover closed when not in use to protect the turntable from dust and debris. Clean the dust cover with a soft, dry cloth. Avoid using harsh chemicals.
• Swen Stylus: Gently clean the stylus regularly using a soft brush designed for stylus cleaning, brushing from back to front. A dirty stylus can degrade sound quality and damage records.
• Ranplasman Stylus: The stylus is replaceable. Refer to the Audio-Technica website or your local dealer for compatible replacement styli.
• Kò platin: Wipe the turntable body with a soft, dry cloth. Do not use solvents or abrasive cleaners.

Depanaj

Espesifikasyon

Garanti ak sipò

For detailed warranty information, product registration, and customer support, please refer to the documentation included with your Audio-Technica AT-LP60XBT-WH turntable or visit the official Audio-Technica website. Contact information for technical assistance and service may also be found there.