1. Entwodiksyon
This manual provides essential instructions for the safe and efficient operation, installation, and maintenance of your TRUE T-19F Reach-In Freezer. Please read this manual thoroughly before installing or operating the unit and retain it for future reference. The TRUE T-19F is a commercial-grade, single-door upright freezer designed for reliable frozen food storage.
Figi 1: Devan view of the TRUE T-19F Reach-In Freezer, showcasing its stainless steel exterior and single door with a handle.
2. Enfòmasyon sou Sekirite
Toujou obsève prekosyon sekirite debaz yo lè w ap itilize aparèy sa a pou diminye risk dife, chòk elektrik, oswa blesi.
- Sekirite elektrik: Ensure the freezer is connected to a properly grounded 115 Volt, dedicated electrical outlet. Do not use extension cords or adapter plugs.
- Vantilasyon: Maintain adequate clearance around the unit for proper ventilation to prevent overheating. Refer to installation guidelines for specific distances.
- Manyen: The unit is heavy. Use appropriate lifting techniques and equipment during unpacking and placement to avoid injury.
- Materyèl ki ka pran dife: Do not store explosive substances or flammable materials inside or near the freezer.
- Timoun: Keep children away from the appliance. Ensure the door cannot be accidentally closed on a child.
3. Debalaj ak Enstalasyon
3.1 Debake
- Retire tout materyèl anbalaj yo avèk prekosyon, tankou tep adezif ak fim pwoteksyon an.
- Inspect the freezer for any shipping damage. Report any damage immediately to the carrier and your supplier.
- Remove any internal packing materials and accessories.
3.2 Plasman
- Place the freezer on a strong, level surface capable of supporting its weight when fully loaded.
- Ensure adequate air circulation. Maintain a minimum of 3 inches (7.6 cm) clearance from walls or other equipment on the sides and rear, and 6 inches (15.2 cm) on top.
- Avoid direct sunlight or proximity to heat-generating appliances (e.g., ovens, stoves).
3.3 Enstalasyon Caster
The unit comes with free casters for mobility. Install them securely into the designated sockets at the bottom of the freezer. Ensure all casters are locked once the unit is in its final position to prevent accidental movement.
3.4 Koneksyon elektrik
Connect the freezer to a dedicated 115 Volt, 60 Hz, single-phase AC power supply with a proper ground. Do not overload the circuit. Allow the unit to stand for at least 2 hours after moving before plugging it in to allow compressor oils to settle.
4. Operasyon
4.1 Premye demaraj
After connecting to power, the freezer will begin to cool. Allow the unit to operate empty for several hours (e.g., 4-6 hours) to reach its set temperature before loading with products.
4.2 Kontwòl Tanperati
The freezer is equipped with a factory-set temperature control. Refer to the control panel for adjustments. Typically, commercial freezers operate at -10°F (-23°C) to 0°F (-18°C). Adjust the thermostat incrementally and allow time for the temperature to stabilize.
4.3 Ranje frizè a
- Distribute products evenly on the three adjustable vinyl-coated wire shelves.
- Do not block the air vents inside the freezer, as this can impede air circulation and cooling efficiency.
- Avoid overloading shelves beyond their weight capacity.
4.4 Operasyon Pòt
The single door is self-closing to minimize temperature fluctuations and energy consumption. Ensure the door closes completely after each use. The door is also equipped with locks for security.
Figi 2: Enteryè view of the TRUE T-19F freezer, showing the adjustable wire shelves and interior lighting.
5. Antretyen ak netwayaj
5.1 Netwayaj regilye
- Enteryè: Clean the interior regularly with a mild soap and water solution. Rinse thoroughly and dry. Do not use abrasive cleaners or sharp objects.
- Eksteryè: Wipe down the stainless steel exterior with a soft cloth and a non-abrasive cleaner designed for stainless steel.
- Joint pòt yo: Clean door gaskets frequently to ensure a proper seal. Inspect for cracks or tears and replace if damaged.
5.2 Netwayaj Bobin Kondansateur
The condenser coil should be cleaned regularly (e.g., monthly or quarterly, depending on environment) to maintain optimal performance and energy efficiency. Disconnect power before cleaning. Use a stiff brush or vacuum cleaner to remove dust and debris from the coil fins. A dirty condenser coil can lead to reduced cooling capacity and increased energy consumption.
5.3 Dekonjle
This unit features an automatic defrost system. However, if excessive ice buildup occurs, manually defrost the unit by emptying it, disconnecting power, and allowing the ice to melt. Do not use sharp objects to remove ice.
NAN. Depanaj
Anvan ou kontakte sèvis la, re-view pwoblèm komen ak solisyon sa yo:
| Pwoblèm | Kòz posib | Solisyon |
|---|---|---|
| Frizè pa refwadi | No power; thermostat set too high; dirty condenser coil; door not sealing. | Check power supply; adjust thermostat; clean condenser coil; inspect door gasket. |
| Twòp bri | Inite a pa nivo; konpozan ki lach; vantilatè a bloke. | Level the unit; check for loose parts; ensure fan is clear. |
| Pòt pa fèmen byen | Obstructed gasket; unit not level; damaged hinge. | Clean gasket; level unit; contact service for hinge repair. |
Si pwoblèm nan pèsiste apre ou fin eseye solisyon sa yo, kontakte yon teknisyen sèvis kalifye.
7. Espesifikasyon
- Mak: VRE
- Non modèl: T-19F Reach in Freezer
- Nimewo Pati: 675-215-RT
- Kalite enstalasyon: Otonòm
- Kapasite: 19 Cu. Ft.
- Voltage: 115 Volts
- gon pòt: Dwa
- Etajè: 3, adjustable vinyl coated wire
- Koulè: Ajan
- Sètifikasyon: rive
8. Garanti ak sipò
For warranty information, please refer to the separate warranty document provided with your purchase or visit the official TRUE website. For technical support, parts, or service inquiries, please contact TRUE customer service or an authorized service provider. Ensure you have your model number (T-19F) and serial number ready when contacting support.
You can find more information about TRUE products and support at the TRUE Store on Amazon.
