Manyèl Itilizatè Transmetè Futaba 2HR 2.4Ghz FHSS ak Reseptè R202GF

1. Entwodiksyon

Mèsi pou acha aasing the Futaba 2HR 2.4Ghz FHSS Transmitter and R202GF Receiver. This system is designed for reliable and precise control of your remote-controlled models. This manual provides essential information for the safe and effective operation, setup, and maintenance of your new radio system. Please read this manual thoroughly before use to ensure proper functionality and to prevent damage.

2. Prekosyon sekirite

Always observe the following safety precautions to prevent injury to yourself or others, and to prevent damage to your equipment.

• Sekirite batri: Use only the specified battery type (AA batteries for the transmitter). Do not mix old and new batteries, or different types of batteries. Remove batteries if the system will not be used for an extended period.
• Anviwònman Fonksyònman: Do not operate your RC model in crowded areas, near power lines, or in adverse weather conditions. Ensure a clear line of sight to your model at all times.
• Tcheke anvan operasyon an: Always perform a range check and verify all control surfaces and functions are operating correctly before each use.
• Entèferans: The 2.4Ghz FHSS system is designed to minimize interference, but always be aware of potential sources of radio interference.
• Timoun: This product is not a toy. Adult supervision is required when children are operating RC models.

3. Pake kontni

Verifye ke tout atik ki nan lis anba a yo enkli nan pakè ou a:

• Futaba 2HR 2.4Ghz FHSS Transmitter
• Futaba R202GF 2-Channel Receiver
• Manyèl Enstriksyon (dokiman sa a)

4. Pwodwi souview

4.1 Futaba 2HR Transmitter

Imaj: Devan view of the Futaba 2HR Transmitter, highlighting the main controls and the 2.4Ghz FHSS branding.

Image: The Futaba 2HR Transmitter shown with its accompanying R202GF Receiver, providing a size comparison.

Imaj: View of the Futaba 2HR Transmitter with the battery cover removed, revealing the battery slots for four AA batteries.

Imaj: Detaye view of the battery compartment, indicating the correct polarity for AA battery installation.

4.2 Futaba R202GF Receiver

Image: Close-up of the Futaba R202GF 2-channel receiver, displaying its model number, 2.4Ghz S-FHSS designation, LED, and servo connection ports.

Image: The Futaba R202GF receiver with its full-length antenna wire, crucial for optimal signal reception.

5. Enstalasyon

5.1 Enstalasyon batri transmetè

1. Locate the battery compartment on the back of the 2HR transmitter.
2. Glise kouvèti batri a louvri.
3. Insert four (4) AA batteries, observing the correct polarity (+/-) as indicated inside the compartment.
4. Fèmen kouvèti batri a byen.

Remak: Pil yo pa enkli ak pwodwi a.

5.2 Koneksyon reseptè

Connect the R202GF receiver to your model's electronic speed controller (ESC) and steering servo. The R202GF is a 2-channel receiver.

• Chèn 1 (CH1): Connect the steering servo.
• Chèn 2 (CH2): Connect the ESC (throttle).
• Asire w tout koneksyon yo solid epi yo byen oryante.

5.3 Konekte Transmetè ak Reseptè a

The transmitter and receiver are typically pre-bound from the factory. If re-binding is necessary, follow these steps:

1. Limen transmetè a.
2. With the receiver powered on (via ESC or separate battery), press and hold the bind button (SW) on the R202GF receiver. The LED on the receiver will change its indication.
3. Release the bind button. The LED should indicate a successful bind (e.g., solid green).
4. Turn off both the transmitter and receiver, then turn them back on to confirm the bind.

Refer to your model's specific instructions for receiver placement and antenna routing for optimal performance.

6. Operasyon Enstriksyon

6.1 Limen/Etenyen

1. Pou limen: First, turn on the transmitter. Then, turn on the receiver (via your model's power switch).
2. Pou etenn: First, turn off the receiver (via your model's power switch). Then, turn off the transmitter.

Always follow this sequence to prevent loss of control or damage to your model.

6.2 Kontwòl debaz yo

• Volan: Rotate left or right to control the steering of your model.
• Deklanche gaz: Pull the trigger towards you for forward movement. Push the trigger away from you for brake/reverse.

6.3 Trim Adjustments

Trim levers are used to make fine adjustments to the steering and throttle neutral positions.

• Taye volan (ST.TRIM): Adjusts the steering neutral point. If your model pulls to one side when the steering wheel is centered, use this trim to correct it.
• Taye gaz (TH.TRIM): Adjusts the throttle neutral point. If your model creeps forward or backward when the throttle trigger is at neutral, use this trim to correct it.

6.4 Servo Ranvèse

The 2HR transmitter includes switches to reverse the direction of the steering and throttle servos if needed.

• Steering Reverse (ST.REV): Flips the steering direction.
• Throttle Reverse (TH.REV): Flips the throttle direction.

Always test servo directions after making any changes to ensure correct operation.

7. Antretyen

• Netwayaj: Use a soft, dry cloth to clean the transmitter and receiver. Do not use solvents or abrasive cleaners.
• Swen batri: Remove batteries from the transmitter if it will not be used for more than a week to prevent leakage and damage.
• Depo: Store the radio system in a cool, dry place, away from direct sunlight and extreme temperatures.
• Enspeksyon: Periodically check all wires and connections for signs of wear or damage.

NAN. Depanaj

9. Espesifikasyon

10. Enfòmasyon sou Garanti

Specific warranty details for the Futaba 2HR Transmitter and R202GF Receiver are typically provided with the product packaging or available on the official Futaba website. Please retain your proof of purchase for warranty claims. For the most current and detailed warranty information, please visit the official Futaba websit la oubyen kontakte distribitè lokal ou a.

11. Sipò pou Kliyan

For technical assistance, spare parts, or further inquiries regarding your Futaba 2HR system, please refer to the official Futaba website or contact their authorized customer support channels. Contact information can usually be found on the manufacturer's websit oswa nan anbalaj pwodwi a.