Entwodiksyon
This manual provides detailed instructions for the setup, operation, maintenance, and troubleshooting of your FAAC TM2 433DS Remote Control Garage Door Opener. Please read this manual thoroughly before using the device to ensure proper function and longevity.
Enstalasyon ak pwogramasyon
1. Enstalasyon batri
The FAAC TM2 433DS remote control requires two Lithium batteries, which are typically included. To install or replace batteries:
- Louvri kontwòl remote la avèk prekosyon casing. This may involve removing a small screw or gently prying open the two halves.
- Jwenn lòj batri a.
- Insert the two Lithium batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
- Fèmen kontwòl remote la casing byen fèm.
2. Programming the Remote Control (DIP Switches)
The FAAC TM2 433DS remote control uses DIP switches for programming. To program your new remote, you will need to match the DIP switch settings of an existing, working remote or your garage door opener receiver.
Entèn view of FAAC TM2 433DS remote control. This image displays the internal components of the FAAC TM2 433DS remote control. Visible are the circuit board, the battery compartment, and a set of DIP switches, which are used for programming the remote to your garage door opener.
- Louvri casing of your new FAAC TM2 433DS remote control.
- Locate the bank of small switches, known as DIP switches, on the circuit board.
- If you have an existing, working remote: Open its casing and observe the position of its DIP switches (ON/OFF or 1/0).
- If you are programming directly from the receiver: Refer to your garage door opener's manual to locate its DIP switches and note their positions.
- Carefully adjust the DIP switches on your new FAAC TM2 433DS remote control to exactly match the settings of the existing remote or receiver. Use a small, non-conductive tool if necessary.
- Once the DIP switches are set, close the remote control casing byen fèm.
- Test the remote control to ensure it operates your garage door opener correctly.
Nòt: If your garage door opener does not use DIP switches, or if you encounter difficulties, consult your garage door opener's specific programming instructions or contact a qualified technician.
Enstriksyon Operasyon
The FAAC TM2 433DS remote control features two buttons for operation.
- Opening/Closing the Garage Door: Press one of the two buttons on the remote control. The garage door will begin to open or close. Pressing the button again during operation will typically stop the door. A third press will reverse its direction.
- Ranje: The maximum effective range for this remote control is approximately 10 meters. Ensure you are within this range for reliable operation. Obstructions can reduce the effective range.
Ensure there are no obstructions in the path of the garage door before and during operation to prevent damage or injury.
Antretyen
Ranplasman batri
If the remote control's range decreases significantly or it stops responding, the batteries may need replacement. Refer to the "Battery Installation" section under Setup for detailed instructions. Always use two new Lithium batteries of the specified type.
Netwayaj
Clean the remote control's exterior with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the casing or internal components. Avoid exposing the remote to excessive moisture.
Depanaj
| Pwoblèm | Kòz posib | Solisyon |
|---|---|---|
| Kontwòl remote pa travay. |
|
|
| Diminye distans fonksyònman. |
|
|
| Garage door opens/closes intermittently. |
|
|
If these troubleshooting steps do not resolve the issue, contact customer support or a qualified technician.
Espesifikasyon pwodwi
| Mak | FAAC |
| Non modèl | TM433DS |
| Nimewo Modèl | TM433DS-2 |
| Dimansyon pwodwi | 0.7 x 0.5 x 0.2 cm |
| Pwa | 40 gram |
| ASIN | B008DRDV1W |
| Kantite Aparèy Sipòte yo | 2 |
| Aparèy konpatib | Pòt Garaj |
| Koneksyon Teknoloji | Radyo Frekans |
| Kantite bouton | 2 |
| Kalite kontwolè | Kontwòl bouton |
| Maksimòm Range | 10 mèt |
| Batri obligatwa | 2 Lithium (included) |
Enfòmasyon sou Garanti
Specific warranty details for the FAAC TM2 433DS remote control may vary by region and retailer. Please retain your proof of purchase for any warranty claims. For detailed warranty terms and conditions, refer to the documentation provided with your purchase or visit the official FAAC websit.
Sipò pou Kliyan
For technical assistance, troubleshooting beyond this manual, or inquiries regarding your FAAC TM2 433DS remote control, please contact FAAC customer support or your authorized dealer. Contact information can typically be found on the manufacturer's websit la oubyen sou dokiman acha ou a.
- Resous sou entènèt: Visit the official FAAC website for FAQs, additional manuals, and support contact details.
- Konsesyonè otorize: Your local FAAC dealer can provide expert advice and service.
