1. Pwodwi souview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
Karakteristik kle:
- Capable of pumping water down to 2 mm residual level.
- Fully submersible design.
- Handles dirt particles up to 3 mm in size.
- Equipped with a 10-meter power cable.
- Features a practical carry handle for easy transport.
Figi 1: Plis paseview of the Sicce Ultrazero Flat Sucking Pump.
2. Enfòmasyon sou Sekirite
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- Toujou dekonekte ponp lan nan ekipman pou kouran an anvan ou manyen li, netwaye li, oswa fè nenpòt antretyen.
- Asire ekipman pou pouvwa a voltage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- Kenbe timoun ak moun ki pa otorize lwen zòn operasyon an.
- Asire w ponp lan byen plonje pandan l ap fonksyone pou anpeche l chofe twòp.
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. Enstalasyon ak Enstalasyon
Follow these steps to properly set up your Ultrazero pump:
- Depale ponp lan: Retire ponp lan ak tout akseswa yo nan anbalaj la avèk prekosyon. Enspekte pou wè si gen nenpòt domaj.
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.
Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- Pozisyon ponp lan: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- Koneksyon pouvwa: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.
Figure 3: The flat base of the pump designed for low residual water levels.
4. Operasyon Enstriksyon
The Ultrazero pump is designed for simple operation:
- Submerge ponp lan: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- Kòmanse ponpe: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- Siveye Nivo Dlo: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- Sispann ponpe: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.
Figure 4: The Ultrazero pump effectively draining water from a small pool.
Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.
Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. Antretyen
Antretyen regilye asire lonjevite ak pèfòmans optimal ponp ou a.
- Netwayaj: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- Enspekte pou debri: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- Enspeksyon kab: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- Depo: When not in use, store the pump in a clean, dry place, protected from frost.
Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
NAN. Depanaj
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| Pwoblèm | Kòz posib | Solisyon |
|---|---|---|
| Ponp pa kòmanse. | Pa gen ekipman pou pouvwa. Kab pouvwa a domaje. Pwoteksyon sou surcharge motè a aktive. | Tcheke koneksyon kouran ak priz. Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| Ponp lan ap mache men pa gen dlo k ap soti. | Intake blocked. Tiyo egzeyat la pliye oswa bouche. Airlock in pump. | Disconnect power, clear intake. Tcheke epi netwaye tiyo egzeyat la. Briefly lift and lower the pump while submerged to release trapped air. |
| Pèfòmans ponpaj redwi. | Blokaj pasyèl. Impeller worn. | Disconnect power, clean pump intake and impeller area. Kontakte sèvis kliyan pou sèvis. |
| Ponp lan kanpe sanzatann. | Overheating due to low water level or blockage. Fòt elektrik. | Disconnect power, check water level and clear blockages. Allow to cool. Si pwoblèm nan pèsiste, kontakte sèvis kliyan. |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. Espesifikasyon teknik
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| Spesifikasyon | Valè |
|---|---|
| Mak | Sicce |
| Nimewo Modèl | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 l/h |
| Maks. Wotè livrezon | 3.1 m |
| Power Consumption (P1) | 80 W |
| Opere Voltage | 220-240V/50Hz |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| Koneksyon presyon | 26.44 mm (3/4") AG |
| Dyamèt Koneksyon Tiyo | 20 milimèt (3/4") |
| Max. Solids Size | 3 mm |
| Nivo dlo rezidyèl | Down to 2-3 mm |
| Dimansyon pwodwi (apeprè) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| Pwa atik | 2.6 kg (5.72 liv) |
| Flote Chanje | Non |
| Pwoteksyon Surcharge | No (Internal thermal protection may exist, but no external reset) |
| Orijin | Te fè nan peyi Itali |
Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. Garanti ak sipò
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
Manifakti: Ebara
Mak: Sicce
For further assistance, visit the official Sicce websit la oubyen kontakte distribitè lokal ou a.